Arturia Analog Factory 2.5 User's Manuel d'utilisateur télécharger pdf (Page 30)

30 ARTURIA – MiniLab – USER’S MANUAL

We’ll show you how to set Pad 2 to the Snare drum note number in section 5.1.3.3.

5.1.3.3 Select the MIDI note number: Snare

Setting Pad 2 to trigger the snare is done the same way, only by choosing a different

MIDI note number (38 in this case):

So now you’re ready to lay down the groove for your song: You have Pads 1 and 2 set to

play the Kick and Snare, and Pads 7 and 8 set to Stop and Start the song.

5.1.4 Assign a Pad to toggle a MIDI CC # between two values

One popular musical effect these days is to take an audio loop, filter it heavily for certain

sections of a song, and switch it back to the full-open sound later in the song. You can

pre-configure one of the MiniLab pads to send those commands to a filter plug-in that

should be readily available in your DAW software.

We’ll use Pad 6 for this example. Select it and then use the pull-down Mode menus to

select “Switched” and “Toggle”:

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Pas de commentaire

Arturia Analog Factory 2.5 User's Manuel d'utilisateur Page 30